Protect America Simon XT Installationshandbuch PDF herunterladen (Seite 2)

FCC Notices

FCC Part 15 Information to the User

Changes or modications not expressly approved by Interlogix, Inc can void the user’s authority to operate the equipment.

FCC Part 15 Class B

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause

harmful interference with the radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by taking one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the affected equipment to the panel receiver to separate outlets, on different branch circuits

• Consult the dealer or an experienced radio/TV technician for help

ACTA Part 68

This equipment complies with Part 68 of the FCC Rules. Located in this equipment is a label that contains, among other information, the FCC

registration number and the ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone

company.

FCC Part 68 Registration No. B4ZUSA-27621-AL-E REN:0.2B

The REN is used to determine the maximum number that may be connected to your telephone line. Excessive RENs on a telephone line may result in

devices not ringing in response to an incoming call. In most areas, the sum of all device RENs should not exceed ve (5.0). To be certain of the number

of devices that may be connected to a line as determined by the total RENs, contact the local telephone company for products approved after July 23,

2001. The REN for this product is part of the product identier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without

a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.

A plug and jack used to connect this equipment to the premises wiring and the telephone network must comply with the applicable FCC Part 68

rules and the requirements as adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be

connected to a compliant modular jack. See the Installation Instructions for details.

Alarm dialing equipment must be able to cease the telephone line and place a call in an emergency situation. It must be able to do this even if other

equipment (telephone answering system, computer modem, etc.) already has the telephone line in use. To do so, alarm dialing equipment must be

connected to a properly installed RJ31X jack that is electrically in series and ahead of all other equipment attached to the same phone line. Proper

installation is depicted in the following diagram. If you have any questions concerning these instructions, consult your local telephone company or a

qualied installer about installing an RJ31X jack and alarm dialing equipment for you.

If this equipment causes harm to the telephone network, the telephone company may temporarily disconnect your service. If possible, you will be

notied in advance. When advance notice is not practical, you will be notied as soon as possible. You will also be notied of your right to le a

complaint to the FCC.

The telephone company might make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment.

You will be given advanced notice in order to maintain uninterrupted service.

If you experience trouble with this equipment, please contact the company that installed the equipment for service and/or repair information. The

telephone company may ask you to disconnect the equipment from the network until the problem has been corrected or you are sure the equipment is

not malfunctioning.

This equipment may not be used on coin service provided by the telephone company. Connections to party lines are subject to tariffs.

SERVICE

If you have any questions about your security system or if you need service, please contact your security dealer.

Company Name: Protect America

Phone Number: 1-800-951-5111, option 2

Monitoring Number: 1-877-274-0604

2002 GE INTERLOGIX

ITI is a registered trademark of GE Interlogix.

Specications are subject to change. Some features are optional.

Customer Premises Equipment and Wiring

Network

Service

Provider’s

Facilities

Telephone Line

Network

Demarcation

Point

RJ31X

Jack

Alarm Dialing

Equipment

Telephone

Unused

RJ-11 Jack

Unused

RJ-11 Jack

Computer

Fax Machine

Answering

System

1 2 3 4 5 6 7 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Protect America Simon XT Installationshandbuch Seite 2

Kommentare zu diesen Handbüchern